UltraMk2FM

Follow these steps:

1)Connect the safety jumper to one of the E-Stop RJ45 ports*.

• For the US version of the LaserCube, you will need to connect the E-Stop included with the unit. Please check the E-Stop Setup Guide section for instructions.

This is required for FDA compliance and the laser will not work without it. 2)Insert the safety key and rotate from the OFF to ON position. The EMSSION LEDs will illuminate to show that the Lasercube is capable of Laser Emission. 3)To disable laser emission, turn the safety key from ON to OFF and remove the key.