Jump to content

UltraMk2FM: Difference between revisions

From LaserOS Wiki
No edit summary
No edit summary
Line 1: Line 1:
 
1) Connect the e-stop pendant to the LaserCube.
Follow these steps:
2) On the laser, turn key to the "ON" position.
 
3) On the e-stop pendant, if the red STOP switch is pushed in, rotate clockwise until it can be raised.
1)Connect the safety jumper to one of the E-Stop RJ45 ports*.
4) On the e-stop pendant, turn the key clockwise to the “ON” position.
*For the US version of the LaserCube, you will need to connect the E-Stop included with the unit. Please check the E-Stop Setup Guide section for instructions.
5) With the red STOP switch raised plus keys on both the laser and pendant set to the “ON” position the Interlock / Emission LEDs will flash slowly, once every 3 seconds.
This is required for FDA compliance and the laser will not work without it.
6) After the second flash, the laser may be enabled by briefly pressing the green START button.  The Interlock / Emission LEDs will begin flashing more quickly, once every second.  After 10 seconds the LEDS will remain solidly on and the laser will be capable of emission.
2)Insert the safety key and rotate from the OFF to ON position.  The EMSSION LEDs will illuminate to show that the Lasercube is capable of Laser Emission.
3)To disable laser emission, turn the safety key from ON to OFF and remove the key.

Revision as of 15:14, 15 April 2025

1) Connect the e-stop pendant to the LaserCube. 2) On the laser, turn key to the "ON" position. 3) On the e-stop pendant, if the red STOP switch is pushed in, rotate clockwise until it can be raised. 4) On the e-stop pendant, turn the key clockwise to the “ON” position. 5) With the red STOP switch raised plus keys on both the laser and pendant set to the “ON” position the Interlock / Emission LEDs will flash slowly, once every 3 seconds. 6) After the second flash, the laser may be enabled by briefly pressing the green START button. The Interlock / Emission LEDs will begin flashing more quickly, once every second. After 10 seconds the LEDS will remain solidly on and the laser will be capable of emission.